My last post was all about upgrading visibility up front in the headlights. I figured, why not check out the back? 👀 But seriously, why have I waited 6 years to do this!? Out back there are 4 lights per side.
Reverse LED: AUXITO LED, 2600 Lumens, 6000K White, Back Up Lamp, Pack of 2 ~$15
Turn Signal LED: AUXITO 3157 LED Bulb Amber, Pack of 2 ~$20
Stop LED: AUXITO 3157 LED Bulbs Red for Brake Lights, Pack of 2 ~$20
Side Marker LED CanBus Error Free 194 Amber LED for Side Marker $11
**note these are polarity sensitive so double check them
Getting the rear lenses out is really simple, pull out the lower carpet block, and untwist the plastic nut, there is also a 2nd one up and back from that one - amazing how 2 screwnuts hold this in place - there is another stabby part that is pressure fit toward the front of the light, just used a screwdriver to pop it out
if you haven't seen behind these lights, it's DIRTY back there! all the water drainage, leaves, etc. are in there - clean it out!
one simple plug in back, push the tab and it comes right out 👏
here's a comparison of the old bulbs vs the LEDs
needless to say, even in daylight you can see which side is the LED and which is OEM
LED reverse light left and OEM on right... it's a no brainer!!! Even in daytime!!
and here's everything done out back, not the brake lights are not on, just as running lights
needless to say - even in daylight, these new LEDs are PHENOMENAL!!
Two big thumbs up!! 👍👍
No comments:
Post a Comment